Your water heater is one of the used and more appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and energy costs.
Regular flushing of one’s water heater has become single most important step you consider to prolong its service life and even save energy. In a period of time, sediments amass in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the standard water heater lasts 3-5 years. Regularly flushing your water heater can double the life of your water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s markets. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a nights.
To drain your water heater, initially you should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located in the water inlet line going into your water heater. Then you’re connect a hose to the drain valve located towards the end of the space heater. Open the drain and allow it to run until all of your water has emptied from the heater. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the water flows out perfectly. This will allow air to vent because of the heater and the hot water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may less corrosive to your plumbing system, particularly in areas which have hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to work for you.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610